Foundation design

Footing analysis and design

Footing Analysis and Design

These calculations quickly check the analysis and/or design of a pad or strip foundation in reinforced or plain concrete.

Watch the video
Pile analysis

Pile Analysis

To speed up foundation design time, this pile analysis calculation does a static analysis of the resistance capacity of single piles, driven or drilled, in multiple geomaterial strata. Steel, concrete or timber piles can be analyzed for compressive and tensile axial loads and lateral loads.

Watch the video
RC Pile cap design

RC Pile Cap Design

This pile cap calculation checks the design of pile caps supporting a single column with up to 9 piles. The column may be subject to axial compression or tension, shear loads, and biaxial bending. Possible load cases include permanent, imposed, snow and wind for all load types. Permanent and imposed surcharge loads may be defined. Steel, concrete or timber piles can be defined with compression, tension and shear capacity.

Watch the video
Concrete raft slab/slab on ground

Concrete Raft Slab/Slab on Ground

This concrete calculation quickly assesses the ability of elements of a raft to support various loading arrangements without exceeding the allowable bearing pressure. It also determines the quantities of reinforcement required to support the loads whilst spanning theoretical circular depressions in the sub-soil which are assumed to form beneath the raft.

Steel sheet piling design

Steel Sheet Piling Design

This calculation for steel sheet piling design checks the stability of either a cantilever or a propped/tied steel sheet pile wall. It determines the required minimum embedment length and then calculates the minimum required plastic section modulus per meter run of wall.

Watch the video

Free trial

Avoid the time-consuming hand calculations and spreadsheets by letting Tekla Tedds do the heavy lifting for you

Get your FREE 45-day full trial here
Person quote
downward quote